63800 2RS Stainless Steel Deep Groove Ball Bearing
The stainless steel deep groove ball bearing SS-63800-2RS is the wider version of the 68 series. It is particularly suitable for achieving a good load capacity in extremely limited space conditions. It is resistant to corrosion.
Features
-
all components are made of stainless steel: the deep groove ball bearing is therefore corrosion resistant and hygienic
-
wider than comparable deep groove ball bearings of the series 62
-
thin section bearing with very thin, square cross section
-
suitable for space-saving installation in radial and axial directions
-
suitable for very high speeds compared to deep groove ball bearings with a larger cross section
-
extra light series with compact dimensions and low weight
-
suitable for radial loads and light axial loads in both directions
-
offers high running accuracy, quiet running and very high speeds
-
seal: contact lip seal on both sides made of rubber (2RS) for high sealing effect
-
If you need this bearing in RS design with only one seal and one open side, you can simply remove one of the two seals: to the instructions
-
good fixed bearing property, but can also be used as a floating bearing, each in both directions
Technical Data
Inside Ø (mm):
10
Outside Ø (mm):
19
Width (mm):
7
Tolerance for inside-Ø (mm):
0/-0,008
Tolerance for outside-Ø (mm):
0/-0,009
Tolerance for width (mm):
0/-0,12
Ring Material:
Stainless Steel
Rows Of Balls:
single row
Seal:
2RS
Internal Clearance:
CN (Standard)
Cage Material:
Stainless Steel
Flange:
no
Slot & Snap Ring:
no
Rolling Element Material:
Stainless Steel
Full Complement Ball Set:
no
- all components are made of stainless steel: the deep groove ball bearing is therefore corrosion resistant and hygienic
- wider than comparable deep groove ball bearings of the series 62
- thin section bearing with very thin, square cross section
- suitable for space-saving installation in radial and axial directions
- suitable for very high speeds compared to deep groove ball bearings with a larger cross section
- extra light series with compact dimensions and low weight
- suitable for radial loads and light axial loads in both directions
- offers high running accuracy, quiet running and very high speeds
- seal: contact lip seal on both sides made of rubber (2RS) for high sealing effect
- If you need this bearing in RS design with only one seal and one open side, you can simply remove one of the two seals: to the instructions
- good fixed bearing property, but can also be used as a floating bearing, each in both directions
| Inside Ø (mm): | 10 |
| Outside Ø (mm): | 19 |
| Width (mm): | 7 |
| Tolerance for inside-Ø (mm): | 0/-0,008 |
| Tolerance for outside-Ø (mm): | 0/-0,009 |
| Tolerance for width (mm): | 0/-0,12 |
| Ring Material: | Stainless Steel |
| Rows Of Balls: | single row |
| Seal: | 2RS |
| Internal Clearance: | CN (Standard) |
| Cage Material: | Stainless Steel |
| Flange: | no |
| Slot & Snap Ring: | no |
| Rolling Element Material: | Stainless Steel |
| Full Complement Ball Set: | no |
Inquiry Form
