UCP211 Pillow Block Housing Unit
The pillow block bearing UCP211 is suitable for high radial loads and is particularly robust with its gray cast iron housing.
Features
-
consisting of a ball bearing insert UC 211 and a cast iron housing P 211
-
suitable for mounting on flat surfaces and high radial load capacities
-
the housing is made of cast iron and therefore inexpensive and robust
-
the bearing insert has an extended inner ring with grub screws
-
The pillow block bearing is mounted on the shaft with two grub screws
-
smooth running and good behavior with tilting due to the extended inner ring
-
static misalignments can be compensated up to an angle of 2°
-
two-piece sealing system: with sheet steel washer reinforced rubber seal inside; outside additionally with upstream slinger made of sheet steel for high mechanical protection against foreign matter
-
lubricated for life; under normal operating conditions relubrication is not required
-
housing with integrated lubrication hole
-
to protect against corrosion, the housing is painted; the bearing insert and the mounting surface are treated with corrosion protection oil
Technical Data
Inside Ø (mm):
55
Tolerance for inside-Ø (mm):
0,024/0
Ring Material:
Rolling bearing steel
Shaft Fastening:
Grub Screws
Housing Type:
Plummer Block
Grub Screw:
M10
Bearing No.:
UC 211
Housing No.:
P 211
Cage Material:
Sheet Steel
Rolling Element Material:
Rolling bearing steel
Housing Material:
Cast Iron
Max. Tightening Torques (Nm) For Bearing Insert:
22
Number of Mounting Holes:
2
- consisting of a ball bearing insert UC 211 and a cast iron housing P 211
- suitable for mounting on flat surfaces and high radial load capacities
- the housing is made of cast iron and therefore inexpensive and robust
- the bearing insert has an extended inner ring with grub screws
- The pillow block bearing is mounted on the shaft with two grub screws
- smooth running and good behavior with tilting due to the extended inner ring
- static misalignments can be compensated up to an angle of 2°
- two-piece sealing system: with sheet steel washer reinforced rubber seal inside; outside additionally with upstream slinger made of sheet steel for high mechanical protection against foreign matter
- lubricated for life; under normal operating conditions relubrication is not required
- housing with integrated lubrication hole
- to protect against corrosion, the housing is painted; the bearing insert and the mounting surface are treated with corrosion protection oil
| Inside Ø (mm): | 55 |
| Tolerance for inside-Ø (mm): | 0,024/0 |
| Ring Material: | Rolling bearing steel |
| Shaft Fastening: | Grub Screws |
| Housing Type: | Plummer Block |
| Grub Screw: | M10 |
| Bearing No.: | UC 211 |
| Housing No.: | P 211 |
| Cage Material: | Sheet Steel |
| Rolling Element Material: | Rolling bearing steel |
| Housing Material: | Cast Iron |
| Max. Tightening Torques (Nm) For Bearing Insert: | 22 |
| Number of Mounting Holes: | 2 |
Inquiry Form
