6818 2RS C3 / 61818 2RS C3 deep groove ball bearings
Very narrow, very light and with extremely good spinning characteristics. The deep groove ball bearing 6818-2RS-C3 is very narrow and can also be used with limited space. The low weight allows for extremely high speeds.
Features
-
thin section bearing with very thin, square cross section
-
suitable for space-saving installation in radial and axial directions
-
suitable for very high speeds compared to deep groove ball bearings with a larger cross section
-
extra light series with compact dimensions and low weight
-
suitable for radial loads and light axial loads in both directions
-
offers high running accuracy and high speeds
-
seal: contact lip seal on both sides made of rubber (2RS) for high sealing effect
-
If you need this bearing in RS design with only one seal and one open side, you can simply remove one of the two seals: to the instructions
-
with increased radial internal clearance (C3): for high temperature gradient between the bearing rings or for fastening with press fit
-
good fixed bearing property, but can also be used as a floating bearing, each in both directions
Technical Data
Inside Ø (mm):
90
Outside Ø (mm):
115
Width (mm):
13
Tolerance for inside-Ø (mm):
0/-0,02
Tolerance for outside-Ø (mm):
0/-0,015
Tolerance for width (mm):
0/-0,2
Rows Of Balls:
single row
Seal:
2RS
Ring Material:
Rolling bearing steel
Internal Clearance:
C3 (Increased Internal Clearance)
Cage Material:
Sheet Steel
Flange:
no
Slot & Snap Ring:
no
Rolling Element Material:
Rolling bearing steel
Full Complement Ball Set:
no
- thin section bearing with very thin, square cross section
- suitable for space-saving installation in radial and axial directions
- suitable for very high speeds compared to deep groove ball bearings with a larger cross section
- extra light series with compact dimensions and low weight
- suitable for radial loads and light axial loads in both directions
- offers high running accuracy and high speeds
- seal: contact lip seal on both sides made of rubber (2RS) for high sealing effect
- If you need this bearing in RS design with only one seal and one open side, you can simply remove one of the two seals: to the instructions
- with increased radial internal clearance (C3): for high temperature gradient between the bearing rings or for fastening with press fit
- good fixed bearing property, but can also be used as a floating bearing, each in both directions
| Inside Ø (mm): | 90 |
| Outside Ø (mm): | 115 |
| Width (mm): | 13 |
| Tolerance for inside-Ø (mm): | 0/-0,02 |
| Tolerance for outside-Ø (mm): | 0/-0,015 |
| Tolerance for width (mm): | 0/-0,2 |
| Rows Of Balls: | single row |
| Seal: | 2RS |
| Ring Material: | Rolling bearing steel |
| Internal Clearance: | C3 (Increased Internal Clearance) |
| Cage Material: | Sheet Steel |
| Flange: | no |
| Slot & Snap Ring: | no |
| Rolling Element Material: | Rolling bearing steel |
| Full Complement Ball Set: | no |
Inquiry Form
